Website:www.Etong-sh.com
Mailbox:all.right.000@hotmail.com
Tele:13817221526
13023568111
Common problems in installation of hot melt adhesive coater
Hot melt adhesive coater is widely used in home accessories, automobile manufacturing, car interior sealing, headlamp production and manufacturing, automobile windshield installation, air filter, non cloth composite, shoe factory, packaging and printing, electronic equipment assembly, garment factory, non dry paste, packaging field, sizing composite field, journal and magazine ordering, etc.
Yitong industry and trade (Shanghai) Co., Ltd. is a company providing new products and new process solutions. We not only provide equipment, but also provide new European technologies and processes to Chinese customers through the carrier of equipment. The main equipment is precision coating, mainly including lithium battery coating, optical film coating, brand tape coating, etc. the industries covered include battery, printing, electronics and precision chemical industries.
The following small series introduces the common problems in the installation of hot melt adhesive coater.
1. When installing the hot melt adhesive coater, be sure to connect a proper and reasonable wire connector. All machines and equipment using direct current must have wire connectors. When wire connectors are not used, all hot melt glue machines have components with conductors and insulators for maintenance, which may still produce working voltage electrical conductors and risk of electric shock accidents.
2. According to the load required by the hot melt adhesive coater and auxiliary equipment, check whether the applied power plug and insulation maintenance meet the requirements. The load of the transmission line must be higher than the high power of the overheated adhesive coater.
3. Ensure that the working voltage externally connected to the hot-melt adhesive machine conforms to the hot-melt adhesive machine itself, such as the hot-melt adhesive coating machine with single-phase electric 220V working voltage specification. If the 220V switching power supply is applied, the automatic spraying equipment of the hot-melt adhesive machine will be damaged, such as the hot-melt adhesive machine with single-phase electric 220V working voltage specification if the switching power supply less than 380V is applied, It is impossible to achieve the design characteristics of mechanical equipment, and it is likely to damage the hot melt adhesive machine. When wiring, ensure that the power plug is properly connected to the external breaker.
4. Ensure the actual Cao operation of the hot melt adhesive machine under the specific working voltage. If the applied working voltage is different from the specific working voltage, the hot melt adhesive machine may be damaged.
Website:www.Etong-sh.com
Mailbox:all.right.000@hotmail.com
Tele:13817221526
13023568111
Filing No.:Hu ICP Bei No. 2021036123-1