How to carry out coater maintenance and repair?

How to carry out coater maintenance and repair?

1. When the hot melt adhesive coating machine is disassembling and maintaining, workers should try not to wear earrings, watches, necklaces, bracelets and other conductive decorations to prevent accidents.

2. Before the maintenance and repair of the hot melt adhesive coating machine, the power user of the hot melt adhesive coating machine and the total power supply connected with the outside world must be cut off, and the live work shall not be allowed.

3, do not disassemble, check and adjust the hot melt adhesive coating machine. No parts, unless you know enough about the performance of the equipment.

4, unless there are other personnel beside the assistance, and in the event of an accident, due to mechanical damage or personnel injury, can be immediately given to help or first aid, otherwise do not separate hot melt coating machine equipment disassembly and maintenance.

5. Only qualified personnel can repair and maintain the hot melt coating machine.

6. Under any circumstances, do not touch the wire connector or other components connected with wire and not loose which may be exposed to the outside world.

7. The power supply must be cut off before removing or moving the protective device or replacing the element on the hot melt adhesive coating machine.

8. If possible, try to stand on the plastic blanket for maintenance and repair work. Never do this on a flooded floor or on a non. Maintain hot melt coating machine in humid environment.

9, the hot melt coating machine maintenance and repair must wear Ann. Full gloves, goggles and long sleeve work clothes, to avoid the body part by high temperature liquid hot sol. Injuries, or burns from high-temperature component surfaces.

10. When releasing or installing the pressure joint, it must be determined that the pressure of the air source for the hot melt coating machine has been reduced to zero.

11. When cleaning the hot melt glue cylinder, avoid using hard tools with fireworks or sharp edges, so as not to scratch the teflon non-adhesive coating inside the barrel.